POWERFLOC

BioGuard PowerFloc is highly effective at restoring water clarity by combining small particles (that cause cloudiness, haze and water discoloration) into large particles. These particles quickly drop to the bottom of the pool so they can be easily vacuumed.

• Clears cloudy water fast
• Makes water sparkling clear
• Combines smal particles into large particles
• Settles suspended particles to bottom
• Improves filtration efficiency

Available sizes: 1 quart

1. SHAKE WELL BEFORE USE.
2. Check filter and backwash or clean filter if necessary.
3. Adjust pH to 7.5 - 8.0 for best results.
4. Use at a rate of 8 fl. oz. per 10,000 gallons.
5. Remove skimmer basket and any product in the skimmer. Pour PowerFloc slowly into skimmer with the pump on and filter valve in RECIRCULATE or WHIRLPOOL position. For filters without RECIRCULATE position: backwash, then with filter in FILTER position, dilute PowerFloc into large plastic pail of water (8 fl. oz. of PowerFloc per 1 gallon of water, always add Power Floc to water, never water to PowerFloc) and apply evenly over surface of pool. Replace skimmer basket after applying PowerFloc.
6. Allow pump to circulate water for 2 hours to distribute PowerFloc throughout the pool.
7. Shut off the pump. Let PowerFloc settle debris to bottom while pool remains undisturbed for 12 to 24 hours (usually overnight).
8. Note: The greater the debris in the water, the faster PowerFloc works. For extremely cloudy pools (cannot see the drain in the deep part of pool) use double the normal dosage.
9. VACUUM TO WASTE all settled debris with filter in WASTE or DRAIN mode. Note: Settling may continue for several days if new debris is introduced by wind or rain. If so, vacuum to WASTE again. DO NOT VACUUM DEBRIS THROUGH FILTER.
10. Backwash and clean filter with BioGuard Strip Kwik and Kleen-It and resume normal filter cycle.
11. Check pH and readjust, if needed, to 7.4 - 7.6.

• MSDS