SOFTSWIM FILTER AID

SoftSwim Filter Aid & Flocculent is a dual-purpose product designed to correct problems like cloudy water, metals, and dead algae in your SoftSwim pool. It can be used as a flocculent for extremely cloudy water and for green extensive algae to remove some dead algae prior to treatment. It can also be used for metals and metal staining as a filter aid to help remove chelated metal from the water.

• Restores water sparkle
• Dual purpose product to aid in filtration or to be used as a settling agent
• Traps small particles that normally pass through filter
• Helps clear cloudy water quickly

Available sizes: 1 lb

• 100% aluminum sulfate
• Dual purpose product to aid in filtration or to be used as a settling agent

To use as Filter Aid in Sand and Cartridge filters:

1. Pre-dissolve 0.5 - 1.0 lb. in a bucket of water for pools from 10,000 - 35,000 gallons and pour slowly into the skimmer with the pump running. This floc will collect finer particles in the filter.
2. Run filter continuously until the pool clears.
3. If the pool does not clear within 48 hours, clean the filter and repeat as necessary. Backwash after 48 hours or if the filter pressure increases 8 - 10 psi above the clean filter pressure.

To use as a Flocculent:

1. Chemically clean the filter according to manufacturer's instructions.
2. Adjust pH to 7.6-7.8. Fill the pool to the top of the skimmer box and turn off the pump.
3. Use 1 lb. of Filter Aid & Flocculent per 6500 gallons of water.
4. Pre-dissolve Filter Aid & Flocculent outdoors in a clean plastic bucket using 1 gallon of water for each pound of product.
5. Broadcast the solution over the entire pool surface.
6. Allow 24 to 48 hours for the floc to settle to the bottom of the pool and vacuum to waste. If some floc becomes suspended, allow an additional 24 hours for it to settle and slowly vacuum to waste.
7. Check and adjust the pH and alkalinity to normal ranges.

• MSDS